How to Fix a Running Toilet with a Button Flush | Expert Tips

Disclaimer

Articles, products, and services offered on this site are for informational purposes only. We recommend using caution and seeking professional advice. This site provides general information. We are part of the Amazon Services LLC Associates Program, an affiliate advertising program. Amazon.com is compensated for sales resulting from links on our website.

Please review our disclaimer before taking action based on anything you read or see.

If you have a running toilet, it’s time to fix it! This easy fix can solve many of your problems and make your toilet run smoother. First, make sure the toilet is in good condition by checking it for leaks and flushes. Second, fix any loose hardware by tightening the screws and brackets that hold the toilet seat and flusher together. Third, add a button flush to help clean the toilet more quickly. Finally, clean the toilet using soap and water and a hose if needed. Yet let’s dive into details on how to fix a running toilet with a button flush.

A simple do-it-yourself solution, Find out if the water level rises to the point of draining into the overflow pipe. If the response is yes, proceed to clean the fill valve.

How to Fix a Running Toilet with a Button Flush

How to Fix a Running Toilet with a Button Flush

To clean the valve, follow these steps:

  • Disconnect the water supply and pull the chain.
  • The cap and the plastic arm should be turned counterclockwise, approximately 1/8 turn. With a quick twisting motion, press down on the plug.
  • Examine the inside of the valve to ensure that no debris remains.
  • Reverse the procedure to reinstall the top on the valve. 
  • Turn off the toilet’s water supply and take note of the tank’s current water level. Wait 10 to 15 minutes and check to see if water drains down your mark. So, if it drains down, start by replacing the flapper, as this is the most typical problem.

Read More: What Are The Dual Flush Toilet Benefits

Replace the flapper if you need it

This will eventually prevent the cistern from pouring water into the bowl (where you flush the feces).

Replace cistern nuts and washers if water is draining down and out the bottom of the cistern.

The cistern is overflowing, which is a common occurrence.

If this is the case, locate the short elbow-shaped pipe that flows from the wall into the cistern (on the bottom side). This pipe should be equipped with a small valve adjusted with a flathead screwdriver. If the line is parallel to the length of the tube, it indicates that the pipe is fully open. Reduce the water flow and slow down the filling rate of your tank by reversing the cross with your flathead. That’s it.

Tank drains steadily

Once you remove the lid, you should be able to see the buttons that activate the flush of your toilet. This is the only component we will be dealing with, so ignore the rest. The most fundamental problem to solve is something that prevents the stopper from closing all the way. You can reach into the water with one hand and locate the space between two plastic sections. 

Don’t get into a panic. The water in the tank is as pure as tap water, so reach in. There may be something preventing the stopper from sealing entirely at the bottom, so push the cistern with one hand and reach under the rising part to feel around inside for something that may be preventing it from fitting correctly.

Bottom line

Replace the flapper and flush valve if the cistern is overflowing. The flush valve may be misaligned or restrict the water’s route to safely drain into the toilet bowl. After removing the lid, you should be able to see the buttons that trigger the toilet’s flushing system. Something may be preventing the stopper from completely sealing at the bottom.

Comments are closed.