How to Flush an Automatic Toilet | Step by Step Guide

Disclaimer

Articles, products, and services offered on this site are for informational purposes only. We recommend using caution and seeking professional advice. This site provides general information. We are part of the Amazon Services LLC Associates Program, an affiliate advertising program. Amazon.com is compensated for sales resulting from links on our website.

Please review our disclaimer before taking action based on anything you read or see.

Automatic toilets can be incredibly annoying, flushing too soon or not at all. We find out why toilet sensors malfunction so often and some simple solutions to the difficulties and teach you how to flush an automatic toilet.

Automatic toilets activate by shaking or waving your hand over the sensor. To use your toilet’s non-contact flushing mechanism, you must wave your hand about 5 to 10 inches above the sensor.

You can activate a flush, bringing the palm of your hand close to the sensor for a few seconds before removing it.

Cover the sensor with a piece of toilet paper and remove it once finished.

Cover the sensor activated by the automatic flush light with a sticky note if it is located on the wall.

If you find that your automatic toilet will not flush, troubleshooting will usually include locating and removing any obstruction in the automatic sensor linked to your toilet’s cistern. If a blockage does not cause the malfunction, additional actions such as parts replacement are necessary.

What to do if your Touchless Toilets is not working correctly?

How to Flush an Automatic Toilet

Whatever the cause of the malfunction, the following steps will help you resolve an automatic toilet that refuses to flush:

Locate the automatic sensor on your unit. 2. It is usually located on the top or side of the toilet cistern, depending on the model.

Take away any obstruction that may be preventing this automatic sensor from detecting your hand movements. Depending on the obstacle, removing it may require removing the tissue roll, towel, or air freshener container from the lid of your tank.

Raise your hand over the tank to start the flushing process. This should work if a physical obstruction causes the malfunction.

If your non-contact toilet still refuses to flush, this indicates that you may have a more significant problem. However, don’t panic; follow these additional procedures to solve the problem:

  • Close the water supply valve next to your toilet.
  • Place the lid of the toilet cistern on a rug or towel.

Flush the water out of the bathroom by hand flushing or shovelling it out.

Ensure that the chain connecting the automatic flushing unit to the flapper at the tank’s base is firmly attached and taught. If it is not ready, you can shorten the chain by using a screwdriver to open the locking hook attached to the device. Reattach the buckle to the sensor unit by securing it to another link in the chain.

Remove and replace the batteries in the battery holder.

Verify that the battery is securely connected to the unit. People with dead batteries may need to move their palms over the sensor to make it work.

Replace the tank cover.

Refill the tank by reopening the faucet. To test the flush sensor, run your hand over it.

These steps should be sufficient for the self-diagnosis of a defective automatic toilet. However, if your bathroom still refuses to flush, it may be time to call in the big guns and contact a professional plumber.

Bottom line

Automatic toilets are activated by shaking your hand over the sensor. A flush can be started by bringing the palm of your hand close to the sensor for a few seconds. If you find that your automatic toilet will not flush, troubleshooting will usually include locating and removing any obstruction in the automatic sensor.

If your automatic bathroom refuses to flush, you may need to follow these additional steps to solve the problem. Close the water supply valve next to your toilet and replace the batteries in the battery holder.

Flush the water out of the toilet by hand flushing or shovelling it out. Replace the tank cover and reopen the faucet to flush the toilet.

Comments are closed.