How to Oil Ceiling Fan Bearings – Step-by-Step Guide

Every electric device needs maintenance, such as a ceiling fan. One of the most important maintenances is oiling the fan bearing. Which can make your fan work more sharply, prevent noise, prolong the life of a fan, and reduce friction. But most of us feel this process is hectic. Today, in this article, we will learn the easiest process by which you can oil the ceiling fan bearings. So, let’s dive into it:

How to Oil Ceiling Fan Bearings

Step 1: Turn off and unplug the ceiling fan.

The first step will be a safety step; always remember to turn the power button while using electric devices; otherwise, you will get a short circuit. So, turn the ceiling button off and unplug the power source. 

Step 2: Remove the fan blades using a screwdriver.

After that, set your letter securely and hold a screwdriver. By using a screwdriver, remove the screws that connect the fan blades to the motor. Remove the screw from one hand and hold it in the other hand so your screw will not fall. Keep all the screws at the site because you have to fix it back at the end.

Step 3: Take off the canopy cover to access the motor housing.

Take off the canopy cover so that you can make access to the motor housing. The canopy cover is the decorative cover of the fan that hides the interior of the fan. Once you take it off, motor housing will be accessible to you.

Step 4: Locate the bearings (usually at the ends of the motor shaft).

Usually, fan bearings are located at different sites. So, you have first to find it out, but usually, it is located at the ends of the motor staff. 

Step 5: Clean the bearings and surrounding areas using a clean cloth.

Once you find out your ceiling fan bearing, you have to see if it is clean or not. If it is not clean, then clean it out. Always clean a circular area before applying anything; otherwise, dust and other particles will rough it. 

So, grab a dry cloth and gently move it all around, and make sure no dust and other particles are remaining.  

Step 6: Apply a few drops of lightweight or sewing machine oil directly onto the bearings.

Once you clean your ceiling fan bearing, grab a few drops of lightweight machine oil or sewing machine and pour it slowly. Don’t pour it too much or too little. It should be little enough to reduce the friction without creating a mess.

Step 7: Rotate the motor shaft manually a few times to distribute the oil.

To distribute the oil into every corner properly. Rotate the motor from your hand several times to flow through all the corners. So it happened several times. You can also pour some drops of white, rotating it so this step will be perfectly done.

Step 8: Reassemble the motor housing and canopy cover.

Once your ceiling fan bearing is done, without any delay, cover it up to resemble the motor housing back. After that, set back the canopy cover so that your fan motor housing will be protected and look amazing.

Step 9: Reattach the fan blades.

Took the screw and reattached it to the fan blades by using a screwdriver as it was. Make sure to perform this step perfectly because if you don’t screw the screw perfectly, there will be chances of noise in rotation and falling of the fan. 

Step 10: Plug in and test the ceiling fan to ensure smooth operation.

After doing all the steps perfectly and attaching it, plug it back in and switch on the button. If the fan works well and the distortion is finished, you did a nice work. If there is still the same issue, it means you did something wrong in the process, so repeat all steps.

My Opinion

Oiling the ceiling fan bearing should be done promptly because it’s part of the maintenance. All you have to do is follow the above steps. If you are confused by any step, read it again carefully. If you are afraid of electric wiring, don’t hesitate to seek guidance from any professional rather than be hurt.

Turn the button off and perform all the steps carefully, with an active mind; otherwise, you can get any shock. If you perform all the steps perfectly, then you will get the results, but if you still hear the noise, then repeat all the steps.